A review of the HP8730 chipless-version printer?
I've been using an HP8610 with continuous ink for what seems like almost 2–3 years... But products that use continuous-ink chips always seem to cause trouble...
I've been using an HP8610 with continuous ink for what seems like almost 2–3 years... But products that use continuous-ink chips always seem to cause trouble...
I've been using an HP8610 with continuous ink for what seems like almost 2–3 years...
But products that use continuous-ink chips always seem to cause trouble...
I'm not sure whether the continuous-ink chips aren't durable enough or whether they were designed that way,
but after using them for a while, errors with the chips inevitably occur, and I end up having to replace them.
Whenever these problems came up, I often found myself in a very difficult situation because I couldn't print.
So, in the end, this time too, because of problems with the chip + cartridge, I decided to replace the entire printer and bought a new one.
It's an HP8730 chipless version.
What is a chipless version?
It means one with no continuous-ink chip installed, modified through its firmware so that it can print even without a cartridge chip.
(In other words, the chip can't fail. Since there's no chip, you don't have to pay to buy one every time.)


So... I successfully installed the HP8730 and completed the test.
Thankfully, it works really well...
However, there was an issue...
Apparently, when using a continuous-ink chip with the chipless version, it sometimes gets stuck loading endlessly when you turn on the power...
In fact, this happens whether I shut it down with the power button and turn it back on, or turn it on after cutting off the power completely.
https://blog.naver.com/mynote12/221908665827
It seems... probably similar to what the author of this blog experienced...
The blog says that if it doesn't boot within 50 seconds, you have to force it to shut down and turn it back on.
But unplugging and replugging the power cord at the back of the printer every time is such a hassle...
so I had no choice but to,

buy a 10-outlet power strip with individual switches...
Now.... if the printer doesn't turn on within 50 seconds, I'll probably have to switch the power off using the individual switch and then turn it back on.. :(
It's not a major inconvenience, but it does seem to have some drawbacks...
Still, it seems better than the hassle and time it takes to buy and replace the chip when the continuous-ink chip breaks. (At least I won't suddenly find myself unable to use the printer...)